his function allows you to use the adhesive electrode by connecting it directly to the unit.
1-Getting started
Remove the plastic backing sheet from the electrode.
Moisten it by spreading a few drops of water onto the adhesive gel using your fingertips and wait 2 minutes.
2- Positioning of the electrode
Position the electrode on your body (cf. positions shown for guidance only).
Fix the electrode to the unit using the snap fasteners taking care to place the belt (chapter II).
Note: The electrode are for personal use. For hygiene reasons, they must always be used by the same person.
3- Starting the program
Start your device by following the “Starting the device” procedure (chapter III).
Contractions should be firm but must never cause any pain.
If the electrode cause you any discomfort: reduce the power level, move the electrode and then gradually increase the power. Also ensure that the electrode are sufficiently moistened.
Now that the settings have been optimized, let your device get to work for the full duration of the program.
4- End of program
Once the program finished, switch off the device by pressing the “” button, then disconnect the unit.
Remove the belt.
Gently remove the electrode from your skin.
Moisten it slightly with a few drops of water and replace it carefully onto its transparent plastic backing sheet.
Keep the adhesive electrode in a plastic bag in a cool place (for example, a separate compartment in your fridge).
Comments
0 comments
Please sign in to leave a comment.