STEP 1
Take the electrodes and remove carefully their protection, dampen them one by one with water on your fingertips on the adhesive gel, and wait for 2 minutes (diagram I. A).
STEP 2
Fit the electrodes on your body as shown in diagram II. A or B or C, page 2 : Positions are shown for information only
Important: For optimal use, carefully read each page and look at the examples of use.
Examples of use (photos above)![]() ![]() |
||
photo ![]() |
photo ![]() |
photo ![]() |
1-Grand pectoral ![]() les électrodes sur l’aire cardiaque |
2-Deltoïde moyen 3-Postérieur 4-Antérieur |
9-Trapèze supérieur 10-Trapèze moyen |
STEP 3
Take connector (CEV8) (photo I. B, page 2) and connect it :
1 - to the electrodes (photo I. C, page 2)
2 - then to the unit (photo I. D, page 2).
STEP 4
The unit is connected to the electrodes through the connector, composed of 2 groups of 4 x 1m. long wires completed by 2 groups of 4 connection plugs.
It is possible to hang your MULTISPORT PRO to your clothing using the clip.
STEP 5
Start your unit following the “Starting the unit” procedure described in paragraph II.
Contractions should be firm but never painful. If you feel an unpleasant sensation around the electrodes : bring the power-on key back to minimum, move the electrode(s) and gradually increase the power.
Once the adjustments have been optimised in this way, leave your appliance to work for the full duration of the program.
STEP 6
Once the program is complete, disconnect the electrodes from the (CEV8) connector, then the latter from the unit.
Then pull off the electrodes gently, dampen them slightly with a few drops of water, then return them carefully onto their support.
Store the adhesive electrodes in a fresh location, in a plastic bag (e.g. vegetable container in the refrigerator).
Comments
0 comments
Please sign in to leave a comment.